Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1211

match ip vlan

Uses a VLAN as the match criterion for an L3 class map.

Syntax [seq sequence number] match ip vlan vlan-idTo remove VLAN as the match criterion, use the no

[seq sequence number] match ip vlan vlan-id command.

Parameters

seq

sequence

number

(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to

100. By default, the sequence number are assigned in multiples of five.

vlan

vlan-id

Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to 4094.

Defaults None.

Command Modes CONF-CLASS-MAP

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS

platforms.

9.10(0.0) Introduced on the S3148.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.4.(0.0) Introduced on the S-Series and Z-Series.

Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure

the match criteria.

Use this command to match an IP class-map against a single VLAN ID .

Commands

• class-map — identifies the class map.

match ip vrf

Uses a VRF as the match criterion for an L3 class map.

Syntax

match ip vrf vrf-id

To remove VRF as the match criterion, use the no match ip vrf vrf-id command.