Administrator Guide

Parameters
min number Enter the keyword min then the minimum threshold number for the WRED profile. The
range is from 1 to 9360.
max number Enter the keyword max then the maximum threshold number for the WRED profile. The
range is from 1 to 9360 KB.
max-drop-drop
number
Enter the keyword max-drop-drop followed by the maximum number of packets for the
WRED profile. The range is from 0 to 100 KB
Defaults none
Command Modes CONFIGURATION (config-wred)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series.
Usage Information To configure the minimum and maximum threshold values for user-defined profiles, use this command.
Additionally, to modify the minimum and maximum threshold values for the pre-defined WRED profiles, use this
command. If you delete the threshold values of the pre-defined WRED profiles, the profiles revert to their original
default values.
Table 5. Threshold Values for the Pre-defined WRED Profiles
Pre-Defined WRED Profile
Name
Minimum Threshold Maximum Threshold
wred_drop 0 0
100
wred_ten_y 467 4671 100
wred_ten_g 467 4671 50
Related
Commands
• wred-profile — creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
1236 Quality of Service (QoS)