Administrator Guide

Version Description
9.4(0.0) Added the tunnel source anylocal command.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information
Added an optional keyword “anylocal” to the tunnel source command. The anylocal argument can be used in
place of the ip address or interface, but only with the multipoint receive-only mode tunnels. The tunnel source
anylocal command allows the multipoint receive-only tunnel to decapsulate tunnel packets addressed to any
IPv4 or IPv6 (depending on the tunnel mode) address configured on the switch that is operationally Up.
1560 Tunneling