Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1631

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information

This command applies to all the VRRP interfaces on a system. When you use this command with the vrrp

delay minimum command, the later timer rules VRRP enabling. For example, if vrrp delay reload is 600

and

vrrp delay minimum is 300:

• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are

up and configured for VRRP.

• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300

seconds (5 minutes) to bring up VRRP on that interface.

For the delay timers to take effect, save the configuration and reload the system.

Related Command

• vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.

vrrp-group

Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.

Syntax

vrrp-group vrrp-id

Parameters

vrrp-id

Enter a number as the group ID. The range is from 1 to 255.

Defaults Not configured.