Administrator Guide

Usage Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer group. Use
this command with caution as it terminates the specified BGP sessions. When a neighbor or peer group is shut
down, use the show ip bgp summary command to confirm its status.
Related
Commands
• show ip bgp summary — display the current BGP configuration.
• show ip bgp neighbors — display the current BGP neighbors.
neighbor soft-reconfiguration inbound
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer group.
Defaults Disabled
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores all the updates the
neighbor receives but does not reset the peer-session.
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already configured with these settings.
388 Border Gateway Protocol