Administrator Guide

Dynamic Host Configuration Protocol (DHCP)
Dynamic host configuration protocol (DHCP) is an application layer protocol that dynamically assigns IP addresses and other configuration
parameters to network end-stations (hosts) based on the configuration policies the network administrators determine.
Topics:
• Commands to Configure the System to be a DHCP Server
• Commands to Configure Secure DHCP
• Commands to Configure DNS
Commands to Configure the System to be a DHCP
Server
To configure the system to be a DHCP server, use the following commands.
clear ip dhcp
Reset the DHCP counters.
Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
binding Enter the keyword binding to delete all entries in the binding table.
address Enter the IP address to clear the binding entry for a single IP address.
conflicts Enter the keyword conflicts to delete all of the log entries created for IP address
conflicts.
server statistics Enter the keywords server statistics to clear all the server counter information.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
13
Dynamic Host Configuration Protocol (DHCP) 489