Administrator Guide

Prompt Interface Type

DellEMC(conf-

if-nu-0)#

Null Interface then zero

DellEMC(conf-

if-po-0)#

Port-channel interface number The range is from 1 to 128.

DellEMC(conf-

if-vl-0)#

VLAN Interface then VLAN number (range 1–4094)

DellEMC(conf-

if-ma-1/1)#

Management Ethernet interface then slot/port information

DellEMC(conf-

if-tu-0)#

Tunnel interface then tunnel ID.

DellEMC(conf-

if-range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list

standard command or the ip access-list extended command.

To enter IP ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter either the ip access-list standard command or the ip access-list extended command. Include a name for the

ACL. The prompt changes to include conf-std-nacl or conf-ext-nacl.

You can return to CONFIGURATION mode by using the exit command.

ISIS ADDRESS-FAMILY Mode

To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to Intermediate

System (IS-IS).

To enter ISIS ADDRESS-FAMILY mode:

1. Verify that you are logged in to ROUTER ISIS mode.

2. Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-af_ipv6.

LLDP Mode

To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, see Link Layer Discovery Protocol

(LLDP).

To enter LLDP mode:

1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify that you are

logged in to INTERFACE mode.

2. Enter the protocol lldp command. The prompt changes to include conf-lldp or conf-if-interface-lldp.

LLDP MANAGEMENT INTERFACE Mode

To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT INTERFACE mode.

To enter LLDP MANAGEMENT INTERFACE mode:

1. Verify that you are logged in to LLDP mode.

2. Enter the management-interface command. The prompt changes to include conf-lldp-mgmtIf.

CLI Basics