Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

551

552

553

554

555

556

557

558

559

560

Parameters

config Enter the keyword config to enable debugging on the GVRP configuration.

event Enter the keyword event to enable debugging on the JOIN/LEAVE events.

pdu Enter the keyword pdu then one of the following Interface keywords and the interface

information:

• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the

slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the slot/port information.

• For a port channel interface, enter the keywords port-channel then a number.

Defaults Disabled.

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on C-Series, E-Series, and S-Series

disable

Globally disable GVRP.

Syntax

disable

To re-enable GVRP, use the no disable command.

Defaults Enabled.

Command Modes CONFIGURATION-GVRP