Administrator Guide

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# clear dampening gigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
DellEMC#
Related
Commands
• show interfaces dampening — display interface dampening information.
• dampening — configure dampening on an interface.
combo-port-type
You can pre-provision the medium of combo ports as copper or fiber.
Syntax
combo-port-type{copper | fiber}
Parameters
copper Enter the keyword copper to provision the combo port as a copper port.
fiber Enter the keyword fiber to provision the combo port as a fiber port.
Defaults None
Command Modes INTERFACE
Command History
Version Description
9.11(0.0) Introduced on the N20xx and N30xx series port extenders.
9.10(0.0) Introduced on the S3100 series.
Usage Information
By default, a combo port is in Hybrid mode. Use the combo-port-type command to provision the combo port
as either copper or fiber. Use the no combo-port-type command to change the combo port to Hybrid mode.
The negotiation auto command is not available on the combo ports in the hybrid mode. You need to
provision the combo port as copper or fiber medium using the combo-port-type command.
594 Interfaces