Administrator Guide

After the penalty decays below the reuse threshold, the interface enables. The configured parameters are as
follows:
• suppress-threshold should be greater than reuse-threshold
• max-suppress-time should be at least 4 times half-life
NOTE: You cannot apply dampening on an interface that is monitoring traffic for other interfaces.
Example
DellEMC(conf-if-gi-1/10)# dampening 20 800 4500 120
DellEMC(conf-if-gi-1/10)#
Related
Commands
• clear dampening — clear the dampening counters on all the interfaces or just the specified interface.
• show interfaces dampening — display interface dampening information.
default interface
Reset a physical interface to its factory default settings.
Syntax
default interface interface-type slot/port - range
Parameters
interface-type
slot/port
Enter the interface type and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
range
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000–ON,
and Z9500.
Usage Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit Ethernet, or 40-Gigabit Ethernet
interface to its factory-default state. By default, a physical interface is disabled (shutdown) with no assigned IP
address or switchport (no ip address). This command removes all software settings and all L3, VLAN, VXLAN, and
port-channel configurations on a physical interface.
Example
DellEMC(conf-if-gi-1/5)# show config
!
interface GigabitEthernet 1/5
description testconfig
no ip address
portmode hybrid
switchport
rate-interval 8
596 Interfaces