Administrator Guide
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.1.1.0 Introduced on the E-Series.
Usage Information When you configure keepalive, the system sends a self-addressed packet out of the configured interface to
verify that the far end of a WAN link is up. When you configure no keepalive, the system does not send
keepalive packets and so the local end of a WAN link remains up even if the remote end is down.
monitor interface
Monitor counters on a single interface or all interfaces. The screen is refreshed every five seconds and the CLI prompt disappears.
Syntax
monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface
(OPTIONAL) Enter the following keywords and the interface information:
• For the Management interface on the stack-unit, enter the keyword
managementEthernet then the slot/port information.
• For a port channel interface, enter the keyword port-channel and then a number.
• For a Tunnel interface, enter the keyword tunnel then the slot/port. The range is
from 1 to 16383.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
614 Interfaces