Administrator Guide

Parameters
gigabitethernet Enter the keyword gigabitethernet then the slot/port information.
tengigabitetherne
t
Enter the keyword tengigabitethernet then the slot or port information.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is different from how you
specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as
show
interfaces interface-type 1/1/1 - 1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage Information The following describes the show interfaces gigabitethernet command following example.
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected speed and
duplex.
Mode Status Displays auto negotiation fault information. When the interface completes auto
negotiation successfully, the autoNegComplete field and the linkstatus field read
“True.”
AutoNegotiation
Advertise
Displays the control words the local interface advertises during negotiation. Duplex is
either half or full. Asym- and Sym Pause is the types of flow control the local interface
supports.
AutoNegotiation
Remote Partner’s
Ability
Displays the control words the remote interface advertises during negotiation. Duplex is
either half or full. Asym- and Sym Pause is the types of flow control the remote interface
supports.
AutoNegotiation
Expansion
ParallelDetectionFault is the handshaking scheme in which the link partner continuously
transmit an “idle” data packet using the Fast Ethernet MLT-3 waveform. Equipment that
640 Interfaces