Administrator Guide

Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port channel
to display flow information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
incoming-
interface interface
Enter the keywords incoming-interface then the interface type and the interface
information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
source-ip address Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP address
format.
source-port
number
Enter the keywords source-port then the source port number. The range is from 1 to
65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The range
is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the nn:nn:nn:nn:nn:nn
format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the number of port channels to 4096.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display flows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identification in a given port-channel if a
valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for a Layer 2 interface
and you are trying to display a Layer 3 flow.
Interfaces 671