Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series.
Example
Related
Commands
• ip udp-helper udp-port — enable the UDP broadcast feature on an interface.
• show ip udp-helper — display the configured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Configure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address command.
Parameters
address Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE (config-if)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant DellEMC
Networking OS Command Line Reference Guide.
The following is a list of the DellEMC Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Usage Information When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured using this
command, the outgoing packet’s IP destination address is replaced with the configured broadcast address.
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a console.
show ip udp-helper — displays the configured UDP helpers on all interfaces.
Interfaces 675