Administrator Guide

Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Example
DellEMC# show crypto ipsec transform-set
Transform-Set Name : dallas
Transform-Set refCnt : 0
AH Transform :
ESP Auth Transform :
ESP Encry Transform : 3des
DellEMC#
show crypto ipsec policy
Display the crypto policy configuration.
Syntax
show crypto ipsec policy
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Example
DellEMC(conf-crypto-policy)# do show crypto ipsec policy
Policy name : pol1
Policy refcount : 0
Sequence Num : 1
SA Mode : IPSEC-MANUAL
Transform-Set Name :
Peer IP Address :
Inbound AH SPI : 0
Inbound ESP Auth SPI : 0
Inbound ESP Encry SPI : 0
Inbound AH Key : [0]::
Inbound ESP Auth Key : [0]::
Inbound ESP Encry Key : [0]::
Outbound AH SPI : 0
Outbound ESP Auth SPI : 0
Outbound ESP Encry SPI: 0
Outound AH Key : [0]::
Outound ESP Auth Key : [0]::
Internet Protocol Security (IPSec) 683