Administrator Guide
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
This command provides egress port information for a given IP flow. This information is useful in identifying which
interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed
packed only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information when load-balance mac
hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
DellEMC# show ip flow interface Gi 2/42 20.1.1.1 100.1.1.2 protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Gi 2/42
Egress Interface: Gi 2/43
DellEMC#
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface
(OPTIONAL)
Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
730 IPv4 Routing