Administrator Guide
IPv6 Basics
IPv6 basic commands are supported on the Dell EMC Networking OS.
NOTE: For information about the Dell EMC Networking OS version and platform that supports IPv6 in each software
feature, see the
IPv6 Addressing
section in the
Dell EMC Networking OS Configuration Guide
.
Topics:
• cam-ipv6 extended-prefix
• clear ipv6 fib
• clear ipv6 route
• clear ipv6 mld_host
• maximum dynamic-routes-ipv6
• ipv6 address autoconfig
• ipv6 address
• ipv6 address eui64
• ipv6 control-plane icmp error-rate-limit
• ipv6 flowlabel-zero
• ipv6 host
• ipv6 name-server
• ipv6 nd dad attempts
• ipv6 nd disable-reachable-timer
• ipv6 nd dns-server
• ipv6 nd prefix
• ipv6 nd reachable-time
• ipv6 route
• ipv6 unicast-routing
• show ipv6 cam stack-unit
• show ipv6 control-plane icmp
• show ipv6 fib stack-unit
• show ipv6 flowlabel-zero
• show ipv6 interface
• show ipv6 mld_host
• show ipv6 route
• trust ipv6-diffserv
cam-ipv6 extended-prefix
Enable LPM partitioning to support IPv6 /65 to /128 route prefixes to be stored in Partition 1.
Syntax
cam-ipv6 extended-prefix <Max-IPv6-prefixes>
To remove LPM partitioning configuration, use no cam-ipv6 extended-prefix.
Parameters
Max-IPv6-Prefix
Maximum number of IPv6 prefixes in the mask length of /65 to /128. The possible values
are 1024, 2048, and 3072.
Defaults LPM is not partitioned with Partition 1 and therefore /65 to /128 prefixes are not converted to /64 prefixes and
are installed and saved in LPM. All the packets for those routes traverse through the default route path.
Command Modes CONFIGURATION
25
IPv6 Basics 755