Administrator Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
maximum dynamic-routes-ipv6
Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.
Syntax maximum dynamic-routes—ipv6 limit {warn-threshold threshold-value | warning-only}
To remove the limit on the maximum number of IPv6 routes used, use the no maximum dynamic-routes-
ipv6 command.
Parameters
limit
Maximum number of IPv6 routes allowed in a VRF. Valid range is from 1 to 8000 (or
maximum allowable for that platform if smaller value).
warning-threshold Warning threshold value is expressed as a percentage of the limit value. When the number
of IPv6 routes reaches the specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is used, once the limit is reached,
additional routes will not be allowed into the RTM ( route table manager ) itself.
warning-only When the warning-only option is used, a syslog message will be thrown when maximum
number of dynamic IPv6 routes reaches the limit. Additional dynamic IPv6 routes will still
be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes
CONFIGURATION-VRF
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500.
Usage Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to 8000), then it has unlimited
space that extends to the maximum number of entries allowed for the system. This command is not applicable to
the default and management VRFs.
758 IPv6 Basics