Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

761

762

763

764

765

766

767

768

769

770

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

Defaults None

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S3148.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.2(0.2) Introduced.

Usage Information This command allows you to create an EUI64 address based on the specified prefix and MAC address only.

Prefixes may be configured on the interface using the ipv6 nd prefix command without creating an EUI64

address.

Example

DellEMC(conf)# int gig 1/4

DellEMC(conf-if-gi-1/4)# ipv6 address 200:1::/64 eui64

DellEMC(conf)# int gig 1/6

DellEMC(conf-if-gi-1/6)# ipv6 address 801:10::/64 eui64

ipv6 control-plane icmp error-rate-limit

Configure the maximum number of ICMP error packets per second that can be sent per second.

Syntax

ipv6 control-plane icmp error-rate-limit {1-200}

To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command.

Parameters

pps Enter the maximum number of error packets generated per second. The range is from 1 to

200, where 0 disables the rate-limiting.

Default 100 pps

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant DellEMC