CLI Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
• show lacp — display the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
Syntax
debug lacp [config | events | pdu [interface-type [in | out]]]
To disable LACP debugging, use the no [config | events | pdu
[interface-type [in | out]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP
event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
interface-type in |
out
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults None
Link Aggregation Control Protocol (LACP)
1027