CLI Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 On the E-Series, available in INTERFACE VLAN context,
reduced the minimum aging time in the INTERFACE VLAN
context from 10 seconds to 1 second.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related
Commands
• mac learning-limit — set the MAC address learning limits for a selected
interface.
• show mac-address-table aging-time — display the MAC aging time.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address {multicast vlan vlan-id
output—range interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-
address output interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
multicast Enter a vlan port to where L2 multicast MAC traffic is
forwarded.
NOTE: Use this option if you want multicast
functionality in an L2 VLAN without IGMP protocols.
output interface For a unicast MAC address, enter the keyword output then
one of the following interfaces for which traffic is
forwarded:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number.
1036
Layer 2