CLI Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show mac-address-table command shown in the
following example.
Column
Heading
Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Interface Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• Po = port channel
• Gi = gigabit Ethernet
• Te = ten-gigabit Ethernet
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
Example
Dell(conf)# do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac
Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po
128 Active
2 00:00:00:00:00:02 Dynamic (N) Po
10 Active
2 00:00:00:00:00:03 Dynamic Po
100 Active
2 00:00:00:00:00:04 Dynamic Po
10 Active
Usage Information The following describes the show mac-address-table count command shown
in the following example.
Line Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Layer 2
1047