CLI Guide

debug lldp interface
To display timer events, neighbor additions or deletions, and other information about incoming and
outgoing packets, enable LLDP debugging.
Syntax
debug lldp interface {interface | all}{events | packet {brief |
detail} {tx | rx | both}}
To disable debugging, use the no debug lldp [interface {interface |
all}{events} {packet {brief | detail} {tx | rx | both}}]
command.
Parameters
interface interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
all Enter the keyword all to display information on all
interfaces.
events Enter the keyword events to display major events such as
timer events.
packet Enter the keyword packet to display information regarding
packets coming in or going out.
brief Enter the keyword brief to display brief packet
information.
detail Enter the keyword detail to display detailed packet
information.
tx Enter the keyword tx to display transmit-only packet
information.
rx Enter the keyword rx to display receive-only packet
information.
both Enter the keyword both to display both receive and transmit
packet information.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
1080
Link Layer Discovery Protocol (LLDP)