CLI Guide

ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
8.3.11.1 Introduced on the Z9000
8.2.1.0 Increased number of VLANs to 4094 (was 2094)
8.1.1.0 Introduced on E-Series
7.6.1.0 Support added for S-Series
7.5.1.0 Introduced on C-Series
Control and Monitoring
115