CLI Guide

Version Description
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information The following describes the debug ip ospf command shown in the Example
below.
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
v: Displays the OSPF version. Dell Networking OS supports
version 2 only.
t: Displays the type of packet sent:
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
l: Displays the packet length.
rid: Displays the OSPF router ID.
aid: Displays the Autonomous System ID.
chk: Displays the OSPF checksum.
aut: States if OSPF authentication is configured. One of the
following is listed:
• 0 - no authentication configured
• 1 - simple authentication configured using the ip ospf
authentication-key command
• 2 - MD5 authentication configured using the ip ospf
message-digest-key command
auk: If the ip ospf authentication-key command is
configured, this field displays the key used.
keyid: If the ip ospf message-digest-key command is
configured, this field displays the MD5 key
to: Displays the interface to which the packet is intended.
dst: Displays the destination IP address.
netmask: Displays the destination IP address mask.
1200
Open Shortest Path First (OSPFv2 and OSPFv3)