CLI Guide

Related
Commands
telnet — telnet to another device.
ip telnet vrf
Configures a TELNET client to use a specific VRF.
Syntax
ip telnet [vrf vrf-name]
To undo the TELENT client configuration, use the ip telnet [vrf vrf-name]
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELENT client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant FTOS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information If you configure a TELNET client to use a specific VRF, then you need not explicitly
specify the same VRF during the TELNET client sessions corresponding to that VRF.
Example
Dell(conf)# ip telnet vrf vrf1
Dell(conf)# do telnet 10.10.10.2
Dell(conf)# no ip telnet vrf vrf1
Dell(conf)#
124
Control and Monitoring