CLI Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Usage Information
The area range command summarizes routes for the different areas.
With the not-advertise parameter configured, you can use this command to
filter out some external routes. For example, if you want to redistribute static routes
to OSPF, but you don't want OSPF to advertise routes with prefix 1.1.0.0, you can
configure the summary-address 1.1.0.0 255.255.0.0 not-advertise to filter out all
the routes fall in range 1.1.0.0/16.
Related
Commands
• area range — summarize routes within an area.
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to
4294967295. The default is 5 seconds.
holdtime Enter a number as the hold time. The range is from 0 to
4294967295. The default is 10 seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Open Shortest Path First (OSPFv2 and OSPFv3)
1273