CLI Guide

ipv6 router ospf
Enable OSPF for IPv6 router configuration.
Syntax
ipv6 router ospf process-id [vrf vrf-name]
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identification number. The range is from 1
to 65535.
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to install IPv6 routes in that VRF.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths
command.
1296
Open Shortest Path First (OSPFv2 and OSPFv3)