CLI Guide

Version Description
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can
contain any number of configured rules. These rules includes the next-hop IP
address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-
group is applied to an interface and the next-hop is reachable, the rules are added
into the PBR CAM region. When incoming traffic hits an entry in the CAM, the
traffic is redirected to the corresponding next-hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related
Commands
• show cam pbr – display the content of the PBR CAM.
• show ip redirect-list – display the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1314
Policy-based Routing (PBR)