CLI Guide

host ip-address Enter the keyword host then the IP address to specify a
host IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the port command parameter.)
source port Enter the keywords source-port then the port number to
be matched in the ACL rule in the ICAP rule
destination-port Enter the keywords destination-port then the port
number to be matched in the ACL rule in the ICAP rule.
source-port-
range
Enter the keywords Source-port-range then the range of
the start port to end port to be matched in the ACL rule in
the ICAP rule.
destination-port-
range
Enter the keywords destination-port-range then the
range of the start port to end port to be matched in the ACL
rule in the ICAP rule.
Defaults none
Command Modes REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
1320
Policy-based Routing (PBR)