CLI Guide

Version Description
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim interface command shown in the
following example.
Field Description
Address Lists the IP addresses of the interfaces participating in PIM.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), of the interfaces participating in
PIM.
Ver/Mode Displays the PIM version number and mode for each
interface participating in PIM:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of PIM neighbors discovered over this
interface.
Query Intvl Displays the query interval for Router Query messages on
that interface (configured with ip pim query-interval
command).
DR Prio Displays the Designated Router priority value configured on
the interface (use the ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that
interface.
The show ip pim interface command does not display information
corresponding to the loop-back interfaces.
Example
Dell# show ip pim interface
Address Interface Ver/ Nbr Query DR DR
Mode Count Intvl Prio
165.87.34.5 Gi 1/10 v2/S 0 30 1
165.87.34.5
10.1.1.2 Vl 10 v2/S 1 30 1
10.1.1.2
20.1.1.5 Vl 20 v2/S 1 30 1
20.1.1.5
165.87.31.200 Vl 30 v2/S 1 30 1
165.87.31.201
Dell#
1344
PIM-Sparse Mode (PIM-SM)