CLI Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
The advertise dot3–tlv power—via—mdi command enables the system to
advertise IEEE 802.3 at power-via-mdi TLV to advertise its power negotiation
capabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You
can configure this command either on a specific interface or globally.
Example
Dell(conf)# int gigabitethernet 1/1
Dell(conf-if-gi-1/1)#protocol lldp
Dell(conf-if-gi-1/1-lldp)#advertise dot3-tlv power-via-mdi
Dell(conf-if-gi-1/1-lldp)#show config
!
protocol lldp
advertise dot3-tlv power-via-mdi
Dell(conf-if-gi-1/1-lldp)#
advertise med power-via-mdi
To advertise the Extended Power via MDI TLV, configure the system.
S3100 Series
Syntax
advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(2.0) Introduced on the S3100 series.
Power over Ethernet (PoE)
1359