CLI Guide

threshold-value
Enter the power threshold limit value in percentage. Range is from 10
to 99. Default value is 99.
Default None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(2.0) Introduced on the S3100 series.
Usage Information
Configure a global threshold limit for the Power over Ethernet (PoE) power budget for a
specified stack unit. A default power threshold value of 99% is configured when there is no
threshold value configured.
Example
Dell(conf)#power budget global-threshold stack-unit 1 10
Dell(conf)#exit
Dell#show power detail stack-unit 1
Unit Total System Redundancy Inline Inline Inline Inline Inline
Power Power Power Power Power Power Power Power
Available Consumed Consumed Threshold Available Allocated Consumed Remaining
(Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts) (Watts)
----------------------------------------------------------------------------------------
1 1100 150 0 10 95 0 0 95
Dell#
power inline
Use this command to enable inline power and configure maximum power allocation with priority for the
powered device connected to an interface.
Syntax
power inline {[max_milliwatts ]| priority {critical | high |
low}}
To disable a device that has been enabled for PoE power supply, use the no power
inline command.
Parameters
max_milliwatts (OPTIONAL) Specify the maximum amount of inline power
allocation to a powered device connected to the interface.
Range is 440–30000 milliwatts (mWs). The default value is
30000 mWs.
NOTE: The max_milliwatt configuration is effective only
in Static mode.
Power over Ethernet (PoE)
1361