CLI Guide

class Enter the keyword class to configure the class mode for
the specified stack unit.
static Enter the keyword static to configure the static mode for
the specified stack unit.
Defaults Static
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(2.0) Introduced on the S3100 series.
Usage Information
The power inline mode command allows you to manage inline power supply
on the stack unit. You can configure class or static mode to manage inline
power in a stack unit.
When class mode is configured, maximum power for the particular class of
device is allocated. Class mode supports power allocation via Layer 2 classification
and power negotiation by Link Layer Discovery Protocol (LLDP) 802.3at standard .
When
static mode is configured, the inline power is allocated based on the
actual power consumption by the powered device. Power negotiation via LLDP is
not supported in
static mode.
Example
Example for static mode:
Dell(conf)#power inline mode stack-unit 1 static
Dell#show power inline stack-unit 1
Global inline power Threshold : 10
Power Reserved for inline Power: 95W
Total Inline Power Consumed: 0W
Remaining inline power Available: 95W
Power Management Mode: Static
Interface Inline Power Inline Power Class Device PoE
Port LLDP
Max / Alloc Consumed Type
Priority Support
(Watts) (Watts)
--------- ------------ ------------ ------- ------
-------- ------
Gi 1/1 30.00/0.00 0.00 NO_DEVICE
- high
Dell#
1364
Power over Ethernet (PoE)