CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
Example
Dell#show power detail stack-unit 1
Unit Total System Redundancy Inline Inline Inline Inline Inline
Power Power Power Power Power Power Power Power
Available Consumed Consumed Threshold Available Allocated Consumed Remaining
(Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts)
(Watts)
-------------------------------------------------------------------------------
1 1100 150 0 10 95 0 0 95
Dell#
show power inline
You can use this command to display the PoE power allocation on a specified stack unit or on an
interface.
Syntax
show power inline {stack-unit unit number | interface interface
SLOT/PORT [/SUBPORT] }
Parameters
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number
Range is from 1 to 6.
interface interface
SLOT/PORT [/
SUBPORT]
Enter the interface keyword, and specify the interface
type followed by the SLOT/PORT [/SUBPORT] numbers.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(2.0) Introduced on the S3100 series.
Usage Information
The following table describes the output fields of the show power inline
command:
Field Description
Interface Displays the line card or the interface slot and port number.
Power over Ethernet (PoE)
1367