CLI Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking
OS.
If there is a change in the running configuration, the system prompts you to save
the new configuration when you reload the system using the reload command.
You can also save your running configuration manually using the copy running-
config command.
You can use the conditional parameter if any configuration changes made to
the NVRAM, such as, stack-group and fanout configurations, must be saved.
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty
lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword console to send a message to the
primary terminal line.
vty Enter the keyword vty to send a message to the virtual
terminal.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Control and Monitoring
137