CLI Guide

set ip ttl Configures the IP time-to-live (TTL) value of the
Encapsulated Remote Switched Port Analyzer (ERSPAN)
traffic. To revert to the default configuration, use the no
form of this command.
ttl_value IP TTL value of the ERSPAN traffic. The range is from 1 to
255. The default value is 255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the drop parameter.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip
dscp and set ip ttl parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The monitor command is saved in the running configuration at Monitor Session
mode level and can be restored after a chassis reload.
Example
Dell# show monitor session
SessID Source Destination Dir Mode Source
IP Dest IP DSCP TTL
------ ------ ----------- --- ----
--------- -------- ---- ---
0 Gi 1/12 remote-ip rx Flow
1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow
1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow
5.1.1.1 3.1.1.2 0 255
Related Command
• show monitor session — displays the monitor session.
1372
Port Monitoring