CLI Guide

show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The
range from 0 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source GigabitEthernet 1/1 destination GigabitEthernet 1/2
direction rx
!
1376
Port Monitoring