CLI Guide

128.140

Gi 1/12 128.142 128 200000 DIS 0 32773 0001.e832.73f7

128.142

Interface

Name Role PortID Prio Cost Sts Cost Link-type Edge

--------------------------------------------------------

Gi 0/10 Desg 128.140 128 200000 FWD 0 P2P No

Gi 0/12 Dis 128.142 128 200000 DIS 0 P2P No

Dell(conf-pvst)#

Commands

• protocol spanning-tree pvst – enter SPANNING TREE mode on the switch.

protocol spanning-tree pvst

To enable PVST+ on a device, enter the PVST+ mode.

Syntax

protocol spanning-tree pvst

To disable PVST+, use the disable command.

Defaults none

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

8.3.1.0 Introduced.

Per-VLAN Spanning Tree Plus (PVST+)

1389