CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
Usage Information The input policy map is used to classify incoming traffic to different flows using
class-map, QoS policy, or incoming packets DSCP. This command enables Policy-
Map-Input Configuration mode (conf-policy-map-in). When you configure an
input policy map for CoPP, you must enter the keyword cpu-qos .
Related
Commands
• service-queue — assigns a class map and QoS policy to different queues.
• service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Quality of Service (QoS)
1427