CLI Guide

Version Description
6.1.1.1 Introduced on the E-Series.
Usage Information The default burst size is 100Kb. If a different value is required, you must configure
the burst size to the required value.
Related
Commands
• rate police — specifies traffic policing on the selected interface.
• qos-policy-input — creates a QoS output policy.
rate-shape
Shape traffic output as part of the designated policy.
Syntax
rate-shape [kbps | pps] peak-rate [burst-kbps | burst-packets]
commited [kbps | pps] commited-rate [burst-kbps | burst-
packets]
Parameters
pps Enter the keyword pps to specify the rate limit in packets
per second (pps).
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of
64. The range is from 0 to 40000000. The default
granularity is Megabits per second (Mbps).
burst-kbps (OPTIONAL) Enter the burst size in KB. The range is from 0
to 40000. The default is 100.
burst-packets Enter the peak rate or committed rate burst size in packets
per seconds.
Defaults Burst size is 10KB. Granularity for rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
1432
Quality of Service (QoS)