CLI Guide

Version Description

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.1 Introduced on the E-Series.

Usage Information There are eight queues per interface on the S6000 and four queues on the S-

Series. This command assigns a class map or QoS policy to different queues.

Commands

• class-map — identifies the class map.

• service-policy input — applies an input policy map to the selected interface.

• service-policy output — applies an output policy map to the selected interface.

set

Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.

Syntax

set {ip-dscp value | mac-dot1p value}

Parameters

ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP

value. The range is from 0 to 63.

mac-dot1p value Enter the keywords mac-dot1p then the dot1p value. The

range is from 0 to 7.

Defaults none

Command Modes CONFIGURATION (conf-qos-policy-in)

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Quality of Service (QoS)

1437