CLI Guide

debug ip rip
Examine RIP routing information for troubleshooting.
Syntax
debug ip rip [interface | database | events [interface] |
trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface (OPTIONAL) Enter the interface type and ID as one of the
following:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display
messages when there is a change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP
protocol changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP
trigger extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Routing Information Protocol (RIP)
1465