CLI Guide

timers basic
Manipulate the RIP timers for routing updates, invalid, holddown times, and flush time.
Syntax
timers basic update invalid holddown flush
To return to the default settings, use the no timers basic command.
Parameters
update Enter the number of seconds to specify the rate at which
RIP routing updates are sent. The range is from zero (0) to
4294967295. The default is 30 seconds.
invalid Enter the number of seconds to specify the time interval
before routing updates are declared invalid or expired. The
invalid value should be at least three times the update timer
value. The range is from zero (0) to 4294967295. The
default is 180 seconds.
holddown Enter the number of seconds to specify a time interval
during which the route is marked as unreachable but still
sending RIP packets. The holddown value should be at least
three times the update timer value. The range is from zero
(0) to 4294967295. The default is 180 seconds.
flush Enter the number of seconds to specify the time interval
during which the route is advertised as unreachable. When
this interval expires, the route is flushed from the routing
table. The flush value should be greater than the update
value. The range is from zero (0) to 4294967295. The
default is 240 seconds.
Defaults
• update = 30 seconds
• invalid = 180 seconds
• holddown = 180 seconds
• flush = 240 seconds
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Routing Information Protocol (RIP)
1491