CLI Guide

debug tacacs+
To assist with troubleshooting, view TACACS+ transactions.
Syntax
debug tacacs+
To disable debugging of TACACS+, use the no debug tacacs+ command.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
1572
Security