CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-config and ECMP traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-
Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
Dell Networking OS supports up to 16 SNMP trap receivers.
If you do not configure this command, traps that controlled by this command are
not sent. If you do not specify a notification-type and notification-
option, all traps are enabled.
Related
Commands
• snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local
engineID] [remote ip-address udp-port port-number engineID]
command.
Parameters
local engineID
Enter the keyword local followed by the engine ID number
that identifies the copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
• The first four octets are set to the private enterprise
number.
1664
Simple Network Management Protocol (SNMP) and Syslog