CLI Guide

Related
Commands
• show snmp engineID — displays the SNMP engine and all the remote engines
that are configured on the router.
• show running-config snmp — displays the SNMP running configuration.
snmp-server group
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth |
priv}}] [read name] [write name] [notify name] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]]
To remove a specified group, use the no snmp-server group [group_name
{v1 | v2c | v3 {auth | noauth | priv}}] [read name] [write
name] [notify name] [access access-list-name | ipv6 access-
list-name | access-list-name ipv6 access-list-name]] command.
Parameters
group_name Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
• v1v2creadg — maps to a community/security-name
with ro permissions.
• 1v2cwriteg — maps to a community/security-name rw
permissions.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c,
or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which
allows for integers twice the width of what is normally
allowed.
The default is 1.
auth (OPTIONAL) Enter the keyword auth to specify
authentication of a packet without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both
authentication and then scrambling of the packet.
read name (OPTIONAL) Enter the keyword read then a name (a string
of up to 20 characters long) as the read view name. The
1666
Simple Network Management Protocol (SNMP) and Syslog