CLI Guide

critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or
debugging.
size (OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
each message. The range is from 40960 to 524288. The
default is 40960 bytes.
Defaults level = 7; size = 40960 bytes
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information When you decrease the buffer size, all messages stored in the buffer are lost.
Increasing the buffer size does not affect messages stored in the buffer.
Related
Commands
• clear logging — clears the logging buffer.
• default logging buffered — returns the logging buffered parameters to the
default setting.
• show logging — displays the logging setting and system messages in the
internal buffer.
1688
Simple Network Management Protocol (SNMP) and Syslog