CLI Guide

55
Stacking
All commands in this chapter are specific to the Dell Networking OS.
You can use the commands to pre-configure a switch, so that the configuration settings are invoked
when the switch is attached to other S-Series units.
For information about using the S-Series stacking feature, see the Stacking S-Series Switches section in
the Dell Networking OS Configuration Guide.
The Dell Networking OS commands for data center bridging features include 802.1Qbb priority-based
flow control (PFC), 802.1Qaz enhanced transmission selection (ETS), and the data center bridging
exchange (DCBX) protocol.
redundancy disable-auto-reboot
Prevent the S-Series stack management unit, stack member unit, and standby unit from rebooting if they
fail.
Syntax redundancy disable-auto-reboot stack-unit [members | stack-
unit-number]
To return to the default, use the no redundancy disable-auto-reboot
stack-unit
command.
Parameters
stack-unit Enter the stack-unit number. The range is from 1 to 6.
members Enter the keyword members for all stack-units.
Defaults Disabled (the failed switch is automatically rebooted).
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
Stacking
1713