CLI Guide

storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[packets_per_second in] command.
storm-control broadcast [percentage decimal_value in | out]| [wred-
profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage
decimal_value in | out] | [wred-profile name]] [packets_per_second in] command.
Parameters
percentagedecim
al_value in | out
Enter the percentage of broadcast traffic allowed in or out
of the network. Optionally, you can designate a decimal
value percentage, for example, 55.5%. The decimal range is
from .1 to .9.
wred-profile
name
Enter the keyword wred-profile followed by the profile
name to designate a wred-profile.
packets_per_seco
nd in
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-MUX (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
1728
Storm Control